Cycles Setting

Selecting "Automatic Cycles" in the "Configurations" menu will
gain access to the page where you can create and modify automatic
Cycles  according to your requirements. Positioning the cursor of the
mouse on the line corresponding to the step desired and clicking twice
will give access to the "Setup Step" page.

This page allows you to enter all the parameters of an individual step, i.e.:

• Description
• Type
• Duration (mm:ss)
• Memorization at end of step
• Alarm and pre-alarm thresholds
• Brake feeder control

(Type of operation, reference set, ramp duration)
• Actuator control

(Type of operation, reference set, ramp duration)
• IF/THEN conditions
• Counter management for repetition "x" times of cycle sections
• Digital outputs for external hardware